Icom ic-718 Instruction Manual page 49

• Meter peak hold
This item selects meter peak hold function ON or OFF.
The default is "on" (ON).
• Scan speed
This item sets the speed at which channels or frequencies
are scanned during scan operations. High or Low can be
selected.
The default is "HI" (High).
• Scan resume
This item sets the scan resume function ON or OFF.
ON: Scan resumes 10 seconds after stopping on a signal
or 2 seconds after a signal disappears.
OFF: Scan does not resume after stopping on a signal. For
the priority watch, setting to OFF pauses the watch
until the signal disappears and the scan resumes.
The default is "on" (ON).
• AM Noise blanker
This item is used in the AM mode to blank unwanted noise,
such as ignition noise.
The default is "on" (ON).
NOTE: The noise blanker function may degrade the audio
if use when listening to regular AM radio broadcasts.
• Auto TS
This item sets auto tuning speed. The tuning dial normally
changes the frequency 1.5 kHz/revolution in 10 Hz tuning
step. When auto tuning step is turned ON this increases to
30 kHz/revolution in 50 Hz tuning step during quick rota-
tion of the dial.
The default is "on" (ON).
• Key type
This item adjusts the CW paddle type. Select from the fol-
lowing options.
• n: normal (for electronic keyer use)
• r: reverse (for electronic keyer use)
• oF: Turns OFF the electronic keyer (for straight key use)
• ud: For using the microphone's [UP]/[DN] keys instead of
the paddle.
The default is "n" (normal).
8
SET MODE
45