Configuring Vlans Using The Web Management Interface; Configuring A Port-Based Vlan - HP 9304m Installation And Getting Started Manual

Installation and Getting Started Guide
The dual-mode feature is disabled by default. The dual-mode feature can be applied only to tagged ports.
NOTE: This feature sometimes results in multiple MAC address entries for the same MAC address in the
device's MAC address table. In this case, each of the entries is associated with a different VLAN. One of the
entries is in the configured VLAN while the other entry is in VLAN 0. The multiple entries are a normal aspect of
the implementation of this feature and do not indicate a software problem.

Configuring VLANs Using the Web Management Interface

Use the procedures in the following sections to configure VLANs using the Web management interface.

Configuring a Port-Based VLAN

1. Log on to the device using a valid user name and password for read-write access.
2. If you have not already enabled OSPF, enable it by clicking on the Enable radio button next to OSPF on the
System configuration dialog, then clicking Apply to apply the change.
3. Click on the plus sign next to Configure in the tree view to expand the list of configuration options.
4. Click on the plus sign next to VLAN in the tree view to expand the list of VLAN option links.
5. Click on the Port link.
• If the device does not have any port-based VLANs, the Port VLAN configuration panel is displayed, as
shown in the following example.
• If at least one port-based VLAN is already configured and you are adding a new one, click on the Add
Port VLAN link to display the Port VLAN configuration panel, as shown in the following example.
• If you are modifying an existing port-based VLAN, click on the Modify button to the right of the row
describing the VLAN to display the Port VLAN configuration panel, as shown in the following example.
6. Enter the VLAN ID and optionally the name.
7. If you want to assign the VLAN to a different Quality of Service (QoS) priority, select the priority from the QoS
field's pulldown menu. For more information, see the "Configuring Quality of Service" chapter in the
Advanced Configuration and Management Guide .
8. Select Enable or Disable next to Spanning Tree to enable or disable the feature on this VLAN.
9. Select the virtual interface (router interface) if applicable.
10. Click the Select Port Members button to display the following panel.
7 - 54