HP 9304m Installation And Getting Started Manual page 326

Message Level Message
Notification Transit TCP in interface <portnum> exceeds
<num> burst packets, stopping for <num>
seconds!!
Informational Cold start
Informational Warm start
Informational <user-name> login to USER EXEC mode
Informational <user-name> logout from USER EXEC
mode
Informational <user-name> login to PRIVILEGED mode
Informational <user-name> logout from PRIVILEGED
mode
Informational SNMP Auth. failure, intruder IP: <ip-addr>
Informational Interface <portnum>, state up
Informational Interface <portnum>, state down
Informational Interface <portnum>, line protocol up
Table A.2: HP Syslog Messages (Continued)
Explanation
Threshold parameters for TCP transit
(through) traffic have been configured on an
interface, and the maximum burst size for
TCP packets on the interface has been
exceeded.
The <portnum> is the port number.
The first <num> is the maximum burst size
(maximum number of packets allowed).
The second <num> is the number of
seconds during which additional TCP
packets will be blocked on the interface.
Note: This message can occur in response
to an attempted TCP SYN attack.
The device has been powered on.
The system software (flash code) has been
reloaded.
A user has logged into the USER EXEC
mode of the CLI.
The <user-name> is the user name.
A user has logged out of the USER EXEC
mode of the CLI.
The <user-name> is the user name.
A user has logged into the Privileged EXEC
mode of the CLI.
The <user-name> is the user name.
A user has logged out of Privileged EXEC
mode of the CLI.
The <user-name> is the user name.
A user has tried to open a management
session with the device using an invalid
SNMP community string.
The <ip-addr> is the IP address of the host
that sent the invalid community string.
A port has come up.
The <portnum> is the port number.
A port has gone down.
The <portnum> is the port number.
The line protocol on a port has come up.
The <portnum> is the port number.
Using Syslog
A - 29