Disabling Or R E -Enabling A - HP 9304m Installation And Getting Started Manual

Installation and Getting Started Guide
1. Log on to the device using a valid user name and password for read-write access. The System configuration
panel is displayed.
2. Click on the plus sign next to Configure in the tree view to display the configuration options.
3. Select the Port link to display the Port table.
4. Click on the Modify button next to the row of information for the port you want to reconfigure.
5. Click next to Full Duplex to select or de-select full duplex mode. Full-duplex mode is selected when the radio
button (small circle) next to Full Duplex contains a black dot.
6. Click Apply to save the changes to the device's running-config file.
7. Select the Save link at the bottom of the dialog. Select Yes when prompted to save the configuration change
to the startup-config file on the device's flash memory.
Disabling or Re-Enabling a Port
The port can be made inactive (disable) or active (enable) by selecting the appropriate status option. The default
value for a port is enabled.
USING THE CLI
To disable port 8 on module 1 of an HP Chassis device, enter the following:
HP9300(config)# interface e 1/8
HP9300(config-if-1/8)# disable
Syntax: disable
Syntax: enable
You also can disable or re-enable a virtual interface. To do so, enter commands such as the following:
HP9300(config)# interface ve v1
HP9300(config-vif-1)# disable
Syntax: disable
To re-enable a virtual interface, enter the enable command at the Interface configuration level. For example, to re-
enable virtual interface v1, enter the following command:
HP9300(config-vif-1)# enable
Syntax: enable
USING THE WEB MANAGEMENT INTERFACE
To disable or enable a port:
1. Log on to the device using a valid user name and password for read-write access. The System configuration
panel is displayed.
2. Click on the plus sign next to Configure in the tree view to display the configuration options.
3. Select the Port link to display the Port table.
4. Click on the Modify button next to the row of information for the port you want to reconfigure.
5. Select either Enable or Disable option next to the Status option.
6. Click Apply to save the changes to the device's running-config file.
7. Select the Save link at the bottom of the dialog. Select Yes when prompted to save the configuration change
to the startup-config file on the device's flash memory.
NOTE: You cannot disable or re-enable a virtual interface using the Web management interface.
4 - 22