Displaying Gvrp Vlan Information - HP 9304m Installation And Getting Started Manual

Installation and Getting Started Guide
Table 8.2: CLI Display of Detailed GVRP Information for a Port (Continued)
This Field...
VLAN Membership

Displaying GVRP VLAN Information

To display information about all the VLANs on the device, enter the following command:
HP9300(config)# show gvrp vlan brief
Number of VLANs in the GVRP Database: 7
Maximum Number of VLANs that can be present: 4095
[VLAN-ID]
1001
1003
4093
4094
===========================================================================
Syntax: show gvrp vlan all | brief | <vlan-id>
8 - 12
Displays...
The VLANs of which the port is a member. For each VLAN, the
following information is shown:
• VLAN ID – The VLAN's ID.
• Mode – The type of VLAN, which can be one of the following:
•
•
•
1
7
11
STATIC-GVRP-BASE-VLAN
STATIC-SINGLE-SPAN-VLAN
FIXED – The port will always be a member of this VLAN and
the VLAN will always be advertised on this port by GVRP. A
port becomes FIXED when you configure the port as a
tagged member of a statically configured VLAN.
FORBIDDEN – The VLAN is one of the special VLANs that is
not advertised or learned by GVRP. In the current release,
the following VLANs are forbidden: the default VLAN (1), the
GVRP base VLAN (4093), or the Single STP VLAN (4094).
NORMAL – The port became a member of this VLAN after
learning about the VLAN through GVRP. The port's
membership in the VLAN depends on GVRP. If the VLAN is
removed from the ports that send GVRP advertisements to
this device, then the port will stop being a member of the
VLAN.
[MODE]
STATIC-DEFAULT
STATIC
STATIC
DYNAMIC
DYNAMIC
[VLAN-INDEX]
0
2
4
7
8
6
5