Determining The Softwarev - HP 9304m Installation And Getting Started Manual

This chapter describes how to copy and save configuration files and software image files.
NOTE: If you are attempting to transfer a file using TFTP but have received an error message, see "Diagnostic
Error Codes and Remedies for TFTP Transfers" on page 10-14.
Determining the Software Versions Installed and Running on a Device
Use the following methods to display the software versions running on the device and the versions installed in
flash memory.
Determining the Flash Image Version Running on the Device
To determine the flash image version running on a device, enter the following command at any level of the CLI:
HP9300# show version
SW: Version 07.5.00T53 Hewlett-Packard Company
Compiled on Oct 28 2001 at 15:54:49 labeled as H2R07500
(3265004 bytes) from Primary H2R07500.bin
HW: ProCurve HP9308 Routing Switch, SYSIF version 21
==========================================================================
SL 1: 8 Port Gig Management Redundant Module, M2, ACTIVE
Serial #: F12345678
2048 KB BRAM, SMC version 1, ICBM version 21
512 KB PRAM(512K+0K) and 2048*8 CAM entries for DMA
512 KB PRAM(512K+0K) and shared CAM entries for DMA
512 KB PRAM(512K+0K) and 2048*8 CAM entries for DMA
512 KB PRAM(512K+0K) and shared CAM entries for DMA
==========================================================================
Active management module:
240 MHz Power PC processor 603 (version 7/1201) 63 MHz bus
512 KB boot flash memory
8192 KB code flash memory
256 KB SRAM
128 MB DRAM
The system uptime is 12 seconds
The system : started=cold start
Updating Software Images and
Configuration Files
Chapter 10
0, version 0209
1, version 0209
2, version 0209
3, version 0209
10 - 1