HP 9304m Installation And Getting Started Manual page 254

• If at least one protocol VLAN is already configured and you are adding a new one, click on the IP Subnet
link to display the IP Sub-net Protocol VLAN configuration panel.
• If you are modifying an existing protocol VLAN, click on the Modify button to the right of the row
describing the VLAN to display the configuration panel for the type of VLAN you are modifying. The
following example shows the IP Sub-net Protocol VLAN configuration dialog, used for configuring an IP
sub-net protocol VLAN (not a protocol, IPX network, or AppleTalk cable VLAN).
5. Enter the VLAN ID that will contain the IP sub-net VLAN in the VLAN ID field.
6. Enter a name for the VLAN in the Protocol_VLAN_Name field.
7. Select the virtual interface from the Router_Interface pulldown list if you configured a virtual interface for
routing into and out of the VLAN.
8. Enter the IP address of the VLAN in the IP_Address field.
9. Enter the network mask in the Mask field.
10. Specify the port that are members for the VLAN:
• Select Dynamic Port if you want the port membership to be dynamic. For information, see "Dynamic
Ports" on page 7-9.
• Click the Change Static Members button if you want to configure static ports. For information, see "Static
Ports" on page 7-10.
• Click the Change Exclude Members button if you want to explicitly exclude some ports. For information,
see "Excluded Ports" on page 7-10.
NOTE: All the ports must be members of the port-based VLAN that contains this IP sub-net VLAN. See
"Layer 3 Protocol-Based VLANs" on page 7-3.
11. Click the Add button (if you are adding a new VLAN) or the Modify button (if you are modifying an existing
VLAN) to save the change to the device's running-config file.
12. Select the Save link at the bottom of the dialog. Select Yes when prompted to save the configuration change
to the startup-config file on the device's flash memory.
Configuring Virtual LANs (VLANs)
7 - 57