Logging On Through The Web Management Interface - HP ProCurve 9315M Quick Start Manual

Line Editing Commands
The CLI supports the following line editing commands. To enter a line-editing command, use the CTRL-key
combination for the command by pressing and holding the CTRL key, then pressing the letter associated with the
command.
Ctrl-Key Combination
Ctrl-A
Ctrl-B
Ctrl-C
Ctrl-D
Ctrl-E
Ctrl-F
Ctrl-K
Ctrl-L; Ctrl-R
Ctrl-N
Ctrl-P
Ctrl-U; Ctrl-X
Ctrl-W
Ctrl-Z
For a complete list of CLI commands and syntax information for each command, see the Command Line Interface
Reference.

Logging On Through the Web Management Interface

To use the Web management interface, open a web browser and enter the IP address of the HP device in the
Location or Address field. The web browser contacts the HP device and displays a login dialog, as shown in
Figure 2.12.
NOTE: If you are unable to connect with the Routing Switch through a Web browser due to a proxy problem, it
may be necessary to set your Web browser to direct Internet access instead of using a proxy. For information on
how to change a proxy setting, refer to the online help provided with your Web browser.
Table 2.3: CLI Line Editing Commands
Description
Moves to the first character on the command line.
Moves the cursor back one character.
Escapes and terminates command prompts and ongoing tasks
(such as lengthy displays), and displays a fresh command prompt.
Deletes the character at the cursor.
Moves to the end of the current command line.
Moves the cursor forward one character.
Deletes all characters from the cursor to the end of the command
line.
Repeats the current command line on a new line.
Enters the next command line in the history buffer.
Enters the previous command line in the history buffer.
Deletes all characters from the cursor to the beginning of the
command line.
Deletes the last word you typed.
Moves from any CONFIG level of the CLI to the Privileged EXEC
level; at the Privileged EXEC level, moves to the User EXEC level.
Installation
2 - 25