HP 9304m Installation And Getting Started Manual page 175

Procurve routing switches
Table of Contents

Advertisement

Installation and Getting Started Guide
Table 6.6: CLI Display of Detailed STP Information for Ports (Continued)
This Field...
BPDU sent and received
USING THE WEB MANAGEMENT INTERFACE
The detailed display is not supported in the Web management interface.
Displaying STP State Information for an Individual Interface
To display STP state information for an individual port, you can use the methods in "Displaying STP Information for
an Entire Device" on page 6-7 or "Displaying Detailed STP Information for each Interface". You also can display
STP state information for a specific port using either of the following methods.
USING THE CLI
To display information for a specific port, enter a command such as the following at any level of the CLI:
HP9300(config)# show interface ethernet 3/11
FastEthernet3/11 is up, line protocol is up
Hardware is FastEthernet, address is 00e0.52a9.bb49 (bia 00e0.52a9.bb49)
Configured speed auto, actual 100Mbit, configured duplex fdx, actual fdx
Member of L2 VLAN ID 1, port is untagged, port state is FORWARDING
STP configured to ON, priority is level0, flow control enabled
mirror disabled, monitor disabled
Not member of any active trunks
Not member of any configured trunks
No port name
MTU 1500 bytes, encapsulation ethernet
5 minute input rate: 352 bits/sec, 0 packets/sec, 0.00% utilization
5 minute output rate: 0 bits/sec, 0 packets/sec, 0.00% utilization
1238 packets input, 79232 bytes, 0 no buffer
Received 686 broadcasts, 0 runts, 0 giants
0 input errors, 0 CRC, 0 frame, 0 ignored
529 multicast
918 packets output, 63766 bytes, 0 underruns
0 output errors, 0 collisions
The STP information is shown in bold type in this example.
Syntax: show interfaces [ethernet <portnum>] | [loopback <num>] | [slot <slot-num>] | [ve <num>] | [brief]
6 - 18
Displays...
The number of BPDUs sent and received on this port since the
software was reloaded.

Advertisement

Table of Contents
loading

This manual is also suitable for:

9315m

Table of Contents