HP 9304m Installation And Getting Started Manual page 69
Procurve routing switches
Hide thumbs
Also See for 9304m:
- Management and configuration manual (690 pages) ,
- Installation and configuration manual (504 pages) ,
- User manual (236 pages)
Table of Contents
Advertisement
Installation and Getting Started Guide
•
Slots in a 15-slot chassis are numbered 1 – 15, from left to right.
This command overrides the default and makes the redundant management module in slot 5 the active module
following the next reload. The change affects only the next reload and does not remain in effect for future reloads.
To make the change permanent across future reloads, enter the write memory command to save the change to
the startup-config file, as shown in the following example:
HP9300(config)# redundancy
HP9300(config-redundancy)# active-management 5
HP9300(config-redundancy)# write memory
NOTE: If you do not save the change to the startup-config file, the change affects only the next reload.
USING THE WEB MANAGEMENT INTERFACE
1.
Log on to the device using a valid user name and password for read-write access. The System configuration
dialog is displayed.
2.
Select the Redundant link to display the following panel.
3.
Select slot number for the active redundant management module from the Active Management Slot pulldown
menu. If you use the default value, Auto Select, the Chassis device uses the redundant management module
in the lower slot number.
•
Slots in a 4-slot chassis are numbered 1 – 4, from top to bottom.
•
Slots in an 8-slot chassis are numbered 1 – 8, from left to right.
•
Slots in a 15-slot chassis are numbered 1 – 15, from left to right.
4.
Click the Apply button to send the configuration change to the active module's running-config file.
5.
If you want the change to remain in effect following the next system reload, select the Save link to save the
configuration change to the active redundant management module's startup-config file. (The change is
automatically sent to the standby module when the active module's system-config file is copied to the standby
module.)
NOTE: If you do not save the change to the startup-config file, the change affects only the next reload.
NOTE: The other options on this panel are described in later sections.
3 - 6
Advertisement
Table of Contents
