Installation and Getting Started Guide
USING THE CLI
To display VLAN information for all the VLANs of which port 7/1 is a member, enter the following command:
HP9300(config)# show vlans e 7/1
Total PORT-VLAN entries: 3
Maximum PORT-VLAN entries: 8
legend: [S=Slot]
PORT-VLAN 100, Name [None], Priority level0, Spanning tree Off
Untagged Ports: (S7)
Tagged Ports: None
IP-subnet VLAN 207.95.11.0 255.255.255.0, Dynamic port disabled
Static ports: (S7)
Exclude ports: None
Dynamic ports: None
Syntax: show vlans [<vlan-id> | ethernet <portnum>]
The <vlan-id> parameter specifies a VLAN for which you want to display the configuration information.
The ethernet <portnum> parameter specifies a port. If you use this parameter, the command lists all the VLAN
memberships for the port.
USING THE WEB MANAGEMENT INTERFACE
You cannot display port-specific VLAN information using the Web management interface.
7 - 62
1
2
3
4
1
2