Converting Avlan Created By Gvrp Into A Statically -Configured Vlan - HP 9304m Installation And Getting Started Manual

Installation and Getting Started Guide
Timer Configuration Requirements
• All timer values must be in multiples of 100 ms.
• The Leave timer must be >= 3* the Join timer.
• The Leaveall timer must be >= 5* the Leave timer.
• The GVRP timers must be set to the same values on all the devices that are exchanging information using
GVRP.
Changing the Join, Leave, and Leaveall Timers
The same CLI command controls changes to the Join, Leave, and Leaveall timers. To change values to the
timers, enter a command such as the following:
HP9300(config-gvrp)# join-timer 1000 leave-timer 3000 leaveall-timer 15000
This command changes the Join timer to 1000 ms, the Leave timer to 3000 ms, and the Leaveall timer to 15000.
Syntax: [no] join-timer <ms> leave-timer <ms> leaveall-timer <ms>
NOTE: When you enter this command, all the running GVRP timers are canceled and restarted using the new
times specified by the command.
Resetting the Timers to Their Defaults
To reset the Join, Leave, and Leaveall timers to their default values, enter the following command:
HP9300(config-gvrp)# default-timers
Syntax: default-timers
This command resets the timers to the following values:
• Join – 200 ms
• Leave – 600 ms
• Leaveall – 10000 ms
Converting a VLAN Created by GVRP into a Statically-Configured
VLAN
You cannot configure VLAN parameters on VLANs created by GVRP. Moreover, VLANs and VLAN ports added
by GVRP do not appear in the running-config and cannot be saved in the startup-config file.
To be able to configure and save VLANs or ports added by GVRP, you must convert the VLAN ports to statically-
configured ports.
To convert a VLAN added by GVRP into a statically-configured VLAN, add the ports using commands such as the
following:
HP9300(config)# vlan 22
HP9300(config-vlan-222)# tagged ethernet 1/1 to 1/8
These commands convert GVRP-created VLAN 22 containing ports 1/1 through 1/8 into statically-configured
VLAN 22.
Syntax: [no] vlan <vlan-id>
Syntax: [no] tagged ethernet <portnum> [to <portnum> | ethernet <portnum>]
Use the same commands to statically add ports that GVRP added to a VLAN.
NOTE: You cannot add the VLAN ports as untagged ports.
8 - 8