Modifying A Port-Based Vlan - HP 9304m Installation And Getting Started Manual

Syntax: [no] spanning-tree
Syntax: spanning-tree [ethernet <portnum> path-cost <value> priority <value>] forward-delay <value>
hello-time <value> maximum-age <time> priority <value>

Modifying a Port-Based VLAN

You can make the following modifications to a port-based VLAN:
• Add or delete a VLAN port.
• Change its priority.
• Enable or disable STP.
Removing a Port-Based VLAN
Suppose you want to remove VLAN 5 from the example in Figure 7.10. To do so, use the following procedure.
USING THE CLI
1. Access the global CONFIG level of the CLI on 9308-A by entering the following commands:
HP9308-A> enable
No password has been assigned yet...
HP9308-A# configure terminal
HP9308-A(config)#
2. Enter the following command:
HP9308-A(config)# no vlan 5
HP9308-A(config)#
3. Enter the following commands to exit the CONFIG level and save the configuration to the system-config file on
flash memory:
HP9308-A(config)#
HP9308-A(config)# end
HP9308-A# write memory
HP9308-A#
4. Repeat steps 1 – 3 on 9308-B.
Syntax: no vlan <vlan-id> by port
Removing a Port from a VLAN
Suppose you want to remove port 1/11 from VLAN 4 on 9308-A shown in Figure 7.10. To do so, use the following
procedure.
USING THE CLI
1. Access the global CONFIG level of the CLI on 9308-A by entering the following command:
HP9308-A> enable
No password has been assigned yet...
HP9308-A# configure terminal
HP9308-A(config)#
2. Access the level of the CLI for configuring port-based VLAN 4 by entering the following command:
HP9308-A(config)#
HP9308-A(config)# vlan 4
HP9308-A(config-vlan-4)#
3. Enter the following commands:
HP9308-A(config-vlan-4)#
HP9308-A(config-vlan-4)# no untag ethernet 1/11
deleted port ethe 1/11 from port-vlan 4.
Configuring Virtual LANs (VLANs)
7 - 17