Configuring Ip Sub-Net, Ipx Network And Protocol-Based Vlans; Based Vlan - HP 9304m Installation And Getting Started Manual

Installation and Getting Started Guide
Default is (1000/Port Speed) for Half-Duplex ports and is (1000/Port Speed)/2 for Full-Duplex ports.
• Priority – value determines when a port will be rerouted in relation to other ports. Possible values: 0 – 255.
Default is 128.

Configuring IP Sub-net, IPX Network and Protocol-Based VLANs

Protocol-based VLANs provide the ability to define separate broadcast domains for several unique Layer 3
protocols within a single Layer 2 broadcast domain. Some applications for this feature might include security
between departments with unique protocol requirements. This feature enables you to limit the amount of
broadcast traffic end-stations, servers, and routers need to accept.
NOTE: See "Configuring AppleTalk Cable VLANs" on page 7-28 for information about configuring an AppleTalk
cable VLAN.
Example: Suppose you want to create five separate Layer 3 broadcast domains within a single Layer 2 STP
broadcast domain:
• Three broadcast domains, one for each of three separate IP sub-nets
• One for IPX Network 1
• One for the Appletalk protocol
Also suppose you want a single router interface to be present within all of these separate broadcast domains,
without using IEEE 802.1q VLAN tagging or any proprietary form of VLAN tagging.
Figure 7.11 shows this configuration.
Figure 7.11 Protocol-based (Layer 3) VLANs
IP sub-net 1
IP sub-net 2
IPX network 1
AppleTalk cable 100
To configure the VLANs shown in Figure 7.11, use the following procedure.
7 - 20
Port 1/8
IP sub-net 1
IP sub-net 2
IPX network 1
AppleTalk cable 100
port 1/8
Ports 1/1 - 1/3, 1/8
Ports 1/4 - 1/6, 1/8
IP sub-net 1
IP sub-net 2
9308M
9304M
Ports 1/4 - 1/6, 1/8
Ports 1/1 - 1/6, 1/8
AppleTalk
IPX network 1
cable 100