HP 9304m Installation And Getting Started Manual page 105

Installation and Getting Started Guide
Port Type
10 Mbps
100 Mbps
Gigabit
USING THE CLI
EXAMPLE:
Suppose you want to enable STP on a system in which no port-based VLANs are active and change the hello-time
from the default value of 2 to 8 seconds. Additionally, suppose you want to change the path and priority costs for
port 5 only. To do so, enter the following commands.
HP9300(config)# span hello-time 8
HP9300(config)# span ethernet 5 path-cost 15 priority 64
Here is the syntax for global STP parameters.
Syntax: span [forward-delay <value>] | [hello-time <value>] | [maximum-age <time>] | [priority <value>]
Here is the syntax for STP port parameters.
Syntax: span ethernet <portnum> path-cost <value> | priority <value>
USING THE WEB MANAGEMENT INTERFACE
To modify the STP parameters:
1. Log on to the device using a valid user name and password for read-write access. The System configuration
panel is displayed.
2. Click on the plus sign next to Configure in the tree view to display the configuration options.
3. Select the STP link to display the STP bridge and port parameters.
4. Click the Modify button in the STP bridge row to display the STP configuration panel, as shown in the
following example.
4 - 26
Table 4.3: Default STP Port Path Costs
Default Path Cost
100
19
4