Configuration Procedure; Configuring A Port-Based Multicast Vlan; Configuration Prerequisites; Configuring User Port Attributes - HP FlexFabric 5950 series Configuration Manual

•
Make sure that no trunk port exists both in a multicast VLAN and a sub-VLAN of the multicast
VLAN.

Configuration procedure

To configure a sub-VLAN-based multicast VLAN:
Step
1. Enter system view.
2. Configure a VLAN as a
multicast VLAN and enter its
view.
3. Assign the specified VLANs
to the multicast VLAN as
sub-VLANs.

Configuring a port-based multicast VLAN

You can assign only Layer 2 Ethernet interfaces or Layer 2 aggregate interfaces to a multicast VLAN.

Configuration prerequisites

Before you configure a port-based multicast VLAN, complete the following tasks:
•
Create VLANs as required.
•
Enable IGMP snooping for the VLAN to be configured as the multicast VLAN.
•
Enable IGMP snooping for all the VLANs that contain the multicast receivers.

Configuring user port attributes

Step
1. Enter system view.
2. Enter interface view.
3. Configure the link type of the
user port as hybrid.
4. Specify the PVID of the
current user port as the
VLAN to which the user port
belongs.
5. Configure the current user
port to permit multicast VLAN
and to untag the packets.
Command
system-view
multicast-vlan vlan-id
subvlan vlan-list
Command
system-view
interface interface-type
interface-number
port link-type hybrid
port hybrid pvid vlan vlan-id
port hybrid
vlan vlan-id-list untagged
66
Remarks
N/A
By default, a VLAN is not a
multicast VLAN.
By default, a multicast VLAN does
not have any sub-VLANs.
Remarks
N/A
N/A
The default setting is access.
For more information about this
command, see Layer 2—LAN
Switching Command Reference.
By default, the PVID for a hybrid
port is VLAN 1.
For more information about this
command, see Layer 2—LAN
Switching Command Reference.
By default, a hybrid port permits
only VLAN 1.
For more information about this
command, see Layer 2—LAN
Switching Command Reference.