Configuring A Port-Based Multicast Vlan; Configuration Prerequisites; Configuring User Port Attributes - HP FlexFabric 5700 Series Configuration Manual

Step
3. Assign the specified VLANs to
the multicast VLAN as
sub-VLANs.

Configuring a port-based multicast VLAN

To configure a port-based multicast VLAN, perform the following steps:
1. Configure a VLAN as the multicast VLAN.
2. Configure the attributes for user ports that are connected to the multicast receivers.
3. Assign the user ports to the multicast VLAN.
You can assign a port to a multicast VLAN only when the port is an Ethernet port or a Layer 2 aggregate
interface.

Configuration prerequisites

Before you configure a port-based multicast VLAN, complete the following tasks:
• Create VLANs as required.
Enable IGMP snooping for the VLAN to be configured as the multicast VLAN.
•
Enable IGMP snooping for all the VLANs that contain the multicast receivers.
•

Configuring user port attributes

Step
1. Enter system view.
2. Enter interface view.
3. Configure the link type of the
user port as hybrid.
4. Specify the PVID of the current
user port as the VLAN to
which the user port belongs.
5. Configure the current user port
to permit the multicast VLAN
and to untag the packets.
Command
subvlan vlan-list
Command
system-view
interface interface-type
interface-number
port link-type hybrid
port hybrid pvid vlan vlan-id
port hybrid vlan vlan-id-list
untagged
51
Remarks
By default, a multicast VLAN does
not have any sub-VLANs.
Remarks
N/A
N/A
The default setting is access.
For more information about this
command, see Layer 2—LAN
Switching Command Reference.
By default, the PVID for a hybrid
port is VLAN 1.
For more information about this
command, see Layer 2—LAN
Switching Command Reference.
By default, a hybrid port permits
only VLAN 1.
For more information about this
command, see Layer 2—LAN
Switching Command Reference.