Jwac Port Settings - D-Link DGS-3612G - xStack Switch Reference Manual

Error Timeout (5-300
sec)
Quarantine Server
URL
Update Server IP
Mask
Port (1-65535)
Click Apply to implement changes made.

JWAC Port Settings

To view JWAC port settings for the Switch, click Security > Japanese Web-based Access Control (JWAC) > JWAC Port
Settings, as shown below:
®
xStack DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
This parameter is used to set the Quarantine Server Error Timeout. When the Quarantine
Server Monitor is enabled, the JWAC Switch will periodically check if the Quarantine works
okay. If the Switch does not receive any response from the Quarantine Server during the
configured Error Timeout, the Switch then regards it as not working properly. Enter a value
between 5 and 300 seconds.
This parameter specifies the JWAC Quarantine Server URL. If the Redirect is enabled and
the Redirect Destination is the Quarantine Server, when an unauthenticated host sends the
HTTP request packets to a random Web server, the Switch will handle this HTTP packet and
send back a message to the host to allow it access to the Quarantine Server with the
configured URL. When a computer is connected to the specified URL, the quarantine server
will request the computer user to input the user name and password to complete the
authentication process.
Update Server Settings
This parameter specifies the Update Server IP address.
This parameter specifies the Server IP net mask.
The accessible TCP/UDP port number for the specified update server network.
Figure 7- 79. JWAC Port Table Parameter window
410