Accelerator Pedal; Shift Lever - Arctic Cat Wildcat ROV 2013 Service Manual

3. Lift the rear body panel off and remove forward
between the ROPS uprights; then tape or plug the filler
hose to prevent contamination of fuel or vapor escaping.
INSTALLING
1. Place the rear body panel onto the vehicle making sure
the outer front mounting tabs are located behind the
splash panel.
2. Secure with the machine screws and tighten securely.
3. Remove the plug or tape from the gas filler hose and
connect the hose to the gasoline filler neck and secure
with the hose clamp. Tighten securely.
188

Accelerator Pedal

REMOVING
Dislodge the throttle cable holding grommet from the actu-
ator arm; then remove two torx-head screws and nuts
securing the accelerator pedal assembly to the splash panel
and remove the accelerator pedal.
WC344A
WC186
INSTALLING
Align the mounting holes with the holes in the splash panel
and secure with the two torx-head screws and nuts; then
snap the throttle cable holding grommet into the actuator
arm.
WC342A
REMOVING
1. Remove the seats; then remove the battery cover and
shift lever handle.
2. Remove the center console leaving the shift lever boot
in the console.
3. Remove the nut from the shift cable pivot bolt; then
remove the four machine screws from the shift lever
axle mounting and remove the shift lever.

Shift Lever

PR709
PR342C