Arctic Cat Wildcat ROV 2013 Service Manual page 28

20. Remove the E-clip (A); then loosen the jam nut (B)
and slide the shift cable out of the mounting bracket
and off the shift arm (C).
21. Disconnect the speed sensor connector (D), stator con-
nector (E), and crankshaft position sensor (F) and tie
the lower harness out of the work space.
22. Remove the rear exhaust pipe and account for a gra-
foil gasket.
23. Remove the upper rear lateral link pivot bolt; then
drop the link down to allow removal of the rear drive
gear case through-bolt.
 NOTE: It may be necessary to use a hoist to slightly
raise the rear of the vehicle to free the link from the
WC362A
frame weldment.
24. Remove two through-bolts and one cap screw secur-
ing the rear drive gear case; then reattach the lateral
link and remove the hoist if used.
WC364A
25. Using a suitable engine lift and equalizer sling, sup-
port the engine; then remove the engine through-bolts,
front first followed by the rear.
WC169A
WC170
WC170A
WC169A
25