Installing Left-Side Components - Arctic Cat Wildcat ROV 2013 Service Manual

3. Install the new stator coil assembly and secure with
three cap screws using a drop of red Loctite #271 on
each. Tighten according to the chart.
Cover Bolt Type
Original Hex-Head
New Hex-Head
4. Place the stator wire harness hold-down into position;
then install the crankshaft position sensor and secure
with two cap screws. Tighten securely.
5. Install the upper cable hold-down and secure with two
cap screws. Tighten securely.
Installing Left-Side
Components
1. Thoroughly clean all gasket material and sealant from
mating surfaces.
2. Install a new O-ring on the oil filler cover and coat it
with clean engine oil; then install the oil filler cover
into the crankcase and secure with the cap screws.
Tighten to 8 ft-lb.
3. Clean the countershaft and trigger splines thoroughly
and install the inner snap ring onto the shaft; then
apply green Loctite #620 to the trigger and counter-
shaft splines and install the trigger. Secure with a flat
washer and outer snap ring.
94
ft-lb N-m
11 15
13 18
H2-017
GZ250
4. If removed, install the shim (E) and cam stopper (F);
then with the cam stopper support (B) in place, install
the spring (C), washer (D), and nut (A). Tighten to 8
ft-lb.
5. Install the shift cam stopper spring onto the shift cam
stopper and secure with a flat washer and flange nut.
Tighten to 8 ft-lb.
H2-023
GZ254
FW-017B
GZ256