Arctic Cat Wildcat ROV 2013 Service Manual page 182

6. Remove the mounting screw securing the brake line
support bracket to the EPS mounting bracket.
7. Remove the steering flex-shaft support bracket; then
slide the EPS unit upwards and to the rear until clear
of the steering rack input coupler.
8. Remove the steering flex-shaft coupler from the EPS
unit; then maneuver the assembly past the brake hoses
and out of the vehicle.
9. Remove the four cap screws securing the EPS mount-
ing bracket to the EPS unit.
 NOTE: No repairs are authorized on the EPS assem-
bly and it must be replaced as a complete assembly.
INSTALLING
1. Install the EPS mounting bracket onto the EPS unit
and secure with the four cap screws. Tighten to 35 ft-
lb.
2. Mark the ends of the EPS input and output shafts to
correspond with the flat-splined segment; then align
the flat-splined segment of the output shaft with the
slot in the rack input coupler and install the EPS into
the vehicle.
WC246A
WC247A
3. Rock the EPS assembly to seat the splines and mount-
ing bracket.
4. Secure the mounting bracket to the frame and tighten
WC253A
to 20 ft-lb.
5. Install the steering flex-shaft coupler onto the EPS
input shaft aligning the flat-splined segment of the
shaft to the slot in the coupler.
WC254A
WC249A
WC250A
179