Assembling Crankcase Half - Arctic Cat Wildcat ROV 2013 Service Manual

5. Install the reverse driven gear dog onto the counter-
shaft and secure with a snap ring.
6. From the opposite end of the countershaft, install the
high/low driven gear dog (A), thrust washer (B), bush-
ing (C), bearing (D), high/low driven gear (E), and
spacer washer (F).
GZ288A
7. Install the drive gear washer and the shift forks. The
countershaft is now ready for installation.
Assembling Crankcase
1. Install the oil pump gerotor assembly and oil pump
cover in the crankcase and secure with two cap
screws. Coat the threads with red Loctite #271 and
tighten securely to 8 ft-lb.
GZ314
2. Install a flat washer, drive pin, and drive gear onto the
oil pump shaft; then secure with a snap ring (flat-side
away from the gear).
GZ313A
GZ312
3. Install the countershaft into the crankcase and secure
with the snap ring (flat side away from the bearing).
Half
GZ283B
GZ305
GZ347
115