Arctic Cat Wildcat ROV 2013 Service Manual page 91

25. Rotate the crankshaft until the first cap screw (from
step 23) can be addressed; then tighten to 11 ft-lb.
Bend the tab to secure the cap screw.
26. Place the C-rings into position in their grooves in the
cylinder heads.
27. Install the cylinder head plugs in the cylinder heads with
the open end facing downward and toward the inside.
CAUTION
The open end of the plug must be positioned downward.
88
CD465
28. Remove the cap screw from the end of the chain ten-
sioner; then using a flat-blade screwdriver, rotate the
adjuster screw inside the tensioner clockwise until the
screw bottoms.
GZ194
 NOTE: The adjuster shaft will be drawn into the ten-
sioner as the adjuster screw is rotated clockwise. The
adjuster shaft tension will be released in step 30.
29. Place the chain tensioner adjuster assembly and gasket
into position on the cylinder and secure with the two
cap screws.
CC012D
30. Using a flat-blade screwdriver, rotate the adjuster
screw inside the tensioner counterclockwise until the
tensioner spring bears tension; then install the cap
screw into the end of the chain tensioner.
GZ162A
CD501
CD469