Accelerator Pedal; Shift Lever - Arctic Cat PROWLER HDX 2015 Service Manual

NOTE: If the hole in the axle shaft does not align
with the slots in the castle nut, tighten the nut until
the hole and slots align.
8. Secure the brake caliper to the knuckle with the two
new "patch-lock" cap screws. Tighten to 20 ft-lb.
9. Install the wheel; then using a crisscross pattern,
tighten in 20 ft-lb increments to 40 ft-lb (steel wheel)
or 80 ft-lb (aluminum wheel).
10. Remove the vehicle from the support stand.

Accelerator Pedal

REMOVING
Dislodge the throttle cable holding grommet from the
actuator arm; then remove two torx-head screws and nuts
securing the accelerator pedal assembly to the splash
panel and remove the accelerator pedal.
26
PR260
INSTALLING
Align the mounting holes with the holes in the splash
panel and secure with the two torx-head screws and nuts;
then snap the throttle cable holding grommet into the
actuator arm.
PR377B
REMOVING
1. Remove the dashboard (see Dashboard in this sec-
tion).
2. Remove the nut securing the shift cable to the shift
arm; then remove the four cap screws securing the
shift axle supports to the frame and remove the shift
lever.

Shift Lever

PR709
HDX256
HDX166A