Arctic Cat Wildcat ROV 2013 Service Manual page 51

7. Remove the two cap screws securing the water pump
to the crankcase.
8. Remove the water pump. Account for an O-ring and
spacer washer (if applicable).
 NOTE: Engines up to ESN 2010689 have two spacer
washers between the water pump mounting bosses.
On engine ESN 2010690 and up, no spacer washers
are installed or required.
 NOTE: The water pump is a non-serviceable compo-
nent and must be replaced as a complete assembly.
9. Remove the cap screws securing the gear shift cover
to the crankcase; then remove the gear shift cover.
Account for a gasket.
10. Remove the nut (A) from the shift cam stopper sup-
port (B); then remove the cam stopper spring (C).
Account for a flat washer (D), cam stopper (F), and
shim (E).
48
11. Remove the cap screw securing the shift cam plate to
the shift cam shaft and remove the shift cam plate;
then remove the shift shaft.
GZ230A
12. Remove the snap ring securing the speed sensor trig-
ger to the shaft and remove the trigger using a suitable
"two-jawed" puller. Account for a gasket.
13. Remove the cap screws securing the oil filler cover to the
crankcase; then remove the cover. Account for an O-ring.
H2-013A
H2-019C
H2-022A
H2-023
GZ250