Arctic Cat Wildcat ROV 2013 Service Manual page 147

Inlet Air Temperature (AIr)
Diagnostic Mode
Display: Inlet air temperature in Fahrenheit or Celsius.
DTC: P0112, P0113, P0114
Usage: Verify correct output of IAT sensor.
NOTE: After engine has been running, IAT read-
ings will be higher than outside air temperature
due to engine and engine compartment heat as
well as intake manifold heating.
Battery (bAtt) Diagnostic Mode
144
Display: System DC voltage.
DTC: P0562, P0563, P2531, P2532
Usage: Verify system voltage under following condi-
tions.
1. Battery voltage with engine and accessories off
(>12.2 VDC for fully charged).
2. Battery voltage with engine running (charging = 13.8
VDC or greater).
3. Battery voltage with electrical accessories operating,
engine idling (13.5 VDC or greater).
4. Battery voltage starter cranking (10.5-11.5 VDC).
DIAGNOSTIC TROUBLE CODES
EFI026
(DTC)
If an EFI or related chassis component fails or an out-of-
tolerance signal is detected by the ECM, a diagnostic trou-
ble code (DTC) will be generated in the ECM and dis-
played on the LCD. The DTC will be displayed alternately
with a wrench icon or malfunction indicator light (MIL).
The DTC will continue to flash, until the malfunction is
corrected and the code cleared.
Code List
NOTE: Each of the following numerical codes will
have a one-letter prefix of C, P, or U. A "C" prefix
denotes a chassis malfunction, a "P" prefix
denotes a power train malfunction, and a "U" pre-
fix denotes a loss of communication with the
gauge.
 NOTE: Normal malfunction codes are cleared from
the LCD when the component is replaced or the mal-
function is corrected; however, intermittent codes
must be cleared as noted in the code chart.
EFI025