Arctic Cat Wildcat ROV 2013 Service Manual page 32

20. Install the heat shield and secure with the appropriate fas-
teners; then install the cargo box supports and secure with
the cap screws and new lock nuts. Tighten to 20 ft-lb.
21. Install the muffler and secure with the spring; then tighten
the front and rear exhaust pipe cap screws to 20 ft-lb.
22. Secure the rear wiring harness to the cargo box supports as
indicated and connect the tail/brakelight connectors to the
light housings.
23. Remove the plug on the radiator and fill the radiator
with the recommended coolant allowing air to bleed
from the loosened filler cap; then loosen the bleed
screw on the water pump allowing air trapped in the
engine to escape. Top off coolant and tighten all bleed
points securely.
WC179B
24. Install the cargo box; then remove the cap from the
gas fill hose and place the rear body panel into posi-
tion. Secure the gas tank fill hose to the filler neck and
secure with the clamp.
25. Secure the rear body panel with the appropriate fas-
teners; then pour in the prescribed engine oil and con-
nect the negative battery cable. Install the battery
cover and seats.
26. Start the engine allowing it to warm up for a few min-
utes; then shut the engine off and check for leaks.
Check all fluid levels and correct as necessary.
WC354A
WC205A
29