Arctic Cat Wildcat ROV 2013 Service Manual page 35

 NOTE: Loop the chain over the cylinder head and
secure it to keep it from falling into the crankcase.
8. Remove the five nuts securing the cylinder head to the
cylinder; then remove the four cylinder head cap
screws and washers.
 NOTE: Removing the starter will simplify removal of
the front cylinder base nuts.
9. Remove the cylinder head from the cylinder, remove
the gasket, and account for two alignment pins; then
remove the cam chain guide.
32
CC266D
10. If the remaining cylinder head is to be serviced, apply
tension to the loose timing chain and rotate the second
cylinder to top-dead-center of the compression stroke;
GZ408
then repeat steps 2-9 on the other cylinder head.

To service valves and cylinder head, see Servicing Top-
Side Components sub-section.

To inspect cam chain guide, see Servicing Top-Side
Components sub-section.
C. Cylinders
D. Pistons
 NOTE: Steps 1-10 in the preceding sub-section
must precede this procedure.
11. Remove the cap screws securing the water hose union
to the cylinder; then remove the union from the cylin-
der. Account for an O-ring.
GZ209A
AT THIS POINT
AT THIS POINT
GZ151
GZ161
GZ140A