Arctic Cat Wildcat ROV 2013 Service Manual page 153

10. Remove the front drive actuator from the differential;
then remove the front boot clamp from the front drive
coupler and slide the boot off.
11. From under the vehicle, slide the driveshaft to the rear
sufficiently to allow differential to move to the rear 6-
8 inches.
12. Remove the upper and lower through-bolts; then slide
the differential rearward and lay it on the right side.
Remove from the vehicle from either left or right side.
Disassembling Input Shaft
1. Using a T-40 torx wrench, remove the cap screws
securing the pinion housing.
150
WC267A
2. Using a rubber mallet, remove the housing. Account
for a gasket. Remove the fork, collar, and spring. Note
the location of all the components for assembling pur-
poses.
WC275A
3. Remove the snap rings from the input shaft; then
remove the input shaft from the pinion housing.
WC 277
GC004A
GC015
CD106
GC009A