Arctic Cat Wildcat ROV 2013 Service Manual page 30

4. Install the engine mounting through-bolts with flat washer,
rear first; then front. Tighten new lock nuts to 40 ft-lb.
5. Support the rear of the vehicle; then remove the lateral
link pivot bolt, drop the lateral link down, and install
the upper through-bolt on the rear drive gear case.
Reinstall the lateral link, secure with the bolt and
tighten a new lock nut to 40 ft-lb.
6. Install the lower front through-bolt and the rear lower
cap screw securing the rear drive gear case; then with
new lock nuts, tighten the through-bolts to 38 ft-lb,
and the cap screw to 20 ft-lb.
7. Coat the threads of all three Allen-head cap screws secur-
ing the front drive coupler flange with blue Loctite #243
and tighten to 40 ft-lb; then connect the starter cable.
8. Crimp the clamp onto the rear drive coupler boot.
9. Connect the speed sensor (D), stator connector (E),
and the CKP sensor (F); then install the gear shift
cable onto the shift arm (C) and secure with the E-clip
(A) and jam nut (B).
WC169A
WC170A
10. Making sure the tab on the throttle body aligns and
fully engages the alignment slot on the intake boot,
install the throttle body and tighten the clamp nut to
30 in.-lb; then install the engine ground cable.
WC187A
WC172B
WC177A
WC362A
WC164A
27