Reverse Override Switch; Accelerator Pedal - Arctic Cat 2015 WILDCAT TRAIL/XT Operator's Manual

Use the headlight switch to select the high
or low headlight beam. When the switch is
in the HI position, the high beam will illu-
minate. When the switch is in the LO
position, the low beam will illuminate.

Reverse Override Switch

This vehicle is equipped with a reverse
speed limiter system. When additional
RPM is needed in reverse, depress and
hold the override switch located on the
center console.

NOTE: The vehicle must be in 4WD
to activate the reverse override.
! WARNING
Never activate the override switch
while the throttle is open as a loss of
control could result.

Accelerator Pedal

Press down on the pedal to increase
engine RPM and vehicle speed; release
the pedal to decrease engine RPM and
vehicle speed.

NOTE: This vehicle is equipped
with an RPM limiter that retards
ignition timing
RPM is approached. When the RPM
limiter is activated, it could be mis-
interpreted as a high-speed misfire.
Seat Latches
1. To remove the seat, lift up on the
latch release (located at the rear of the
seat); then raise the rear of the seat
and tilt it forward.
WT104A
when maximum
2. To lock the seat into position, place
the front of the seat into the seat
retainers and push down firmly on the
rear of seat. The seat should automat-
ically lock into position.
! WARNING
Make sure the seats are secure
before driving the vehicle. Serious
injury or death could result if the
seats are not properly secured.
Seat Belts
This vehicle is equipped with seat belts
for the operator and the passenger. To
fasten and release the seat belt properly,
use the following procedure.
1. Place the seat belt across your lap as
low as possible without twisting the
belt making sure the shoulder strap is
below the neck and across the chest.
! WARNING
Only appropriate-sized passengers
may ride in this vehicle. Passengers
must be able to place both feet flat on
the floor while keeping their back
against the back of the seat and hold-
ing on to the hand holds.
2. Push the latch-plate into the buckle
slot until it "clicks" and latches
securely. The belt will retract when
the buckle is released.
! WARNING
Falling outside a moving vehicle could
result in serious injury or death.
Always fasten your seat belt securely
and ensure the passenger seat belt is
properly and securely fastened prior to
operating or riding in this vehicle.
WT003A
27