Arctic Cat Wildcat ROV 2013 Service Manual page 104

2. Install the clutch into an appropriate driven clutch
compressor tool. Finger-tighten the wing nut to
tighten.
3. Remove the helix; then after marking the spider assembly
for assembling purposes, remove the spider assembly.
4. Remove the E-clips securing the cam rollers to the
spider; then remove the thrust washer and roller.
WC639
 NOTE: The relief in the roller is directed towards the
spider.
5. Remove the spring and movable sheave.
6. Using a suitable punch, remove the roller pin securing
the roller axle in movable sheave; then drive out the
axle and account for a thrust washer.
WC638
WC636
Assembling
1. Install the roller and thrust washer in place with the
washer toward the outside of sheave.
WC635
WC628
WC627
WC626
101