Separating Crankcase Halves - Arctic Cat Wildcat ROV 2013 Service Manual

 NOTE: For efficiency, it is preferable to remove and
disassemble only those components which need to be
addressed and to service only those components. The
technician should use discretion and sound judgment.
Separating Crankcase
Halves
1. Remove the oil strainer cap; then remove the oil
strainer.
2. Remove the cap screws securing the lower crankcase
to the upper crankcase halves; then using a rubber
hammer, free the lower crankcase and remove.
Account for two alignment pins.
3. Remove the secondary drive assembly; then remove
the secondary driven shaft assembly and set aside.
Account for one locating ring.
106
H2-012A
 NOTE: Do not disassemble these assemblies
unless service is required. If disassembled, second-
ary gear sets will have to be reset for backlash and
gear contact (see Servicing Center Crankcase Com-
ponents sub-section).
4. Remove one cap screw from the right-side crankcase
and eight cap screws from the left-side crankcase;
then using a rubber mallet, separate the crankcase
halves leaving all components in the right-side case.
Account for a thrust washer on the crankshaft and flat
washers on gear shift shaft, countershaft, and reverse
idler. Note the location of two alignment pins.
GZ446
H2-012B
GZ448A
GZ269A
GZ454A