Arctic Cat Wildcat ROV 2013 Service Manual page 31

11. Connect the ECT connector (A), front coil primary
connector (B), TPS connector (C), MAP/IAT connec-
tor (D), and ISC connector (E).
12. Install the fuel rail with fuel injectors and secure with
the cap screws. Tighten to 6 ft-lb.
13. Connect the gas line connectors to the fuel rails and
the electrical connectors to the fuel injectors.
28
WC210A
14. Place the inlet air duct into position; then install the
CVT intake cooling duct and secure with the clamp.
WC204A
15. Set the air filter housing into place and secure with the
three screws on the CVT housing and tighten to 6 ft-
lb; then connect and secure the throttle body inlet air
boot (A), crankcase breather hose (B), and inlet air
duct (C). Tighten the inlet air boot clamp to 30 in.-lb
and install the air filter housing strap.
WC206A
16. Install the CVT cooling outlet duct; then with a new
grafoil gasket, install the rear exhaust pipe and cap
screws loosely.
17. Install the radiator/fan assembly and secure with the
mounting screws; then connect and secure the coolant
hoses with the clamps. Tighten securely.
18. Connect the fan connectors, rear spark plug cap, and
rear coil primary connector.
19. Install the gas tank cradle and gas tank and secure with the
hold down bracket; then connect the fuel hose and fuel
pump/fuel level sensor connector.
WC203A
WC209A
WC146A