Arctic Cat Wildcat ROV 2013 Service Manual page 16

2. Remove the three mounting screws; then remove the
headlight assembly.
3. Install the new headlight assembly and connect the
wiring harness. Install the hood.
4. Adjust the headlight using the Checking/Adjusting
Headlight Aim instructions in this sub-section.
To replace the taillight/brakelight assembly, use the fol-
lowing procedure.
1. Disconnect the taillight/brakelight connector; then
remove the lock nuts securing the assembly to the
mounting bracket.
2. Remove the taillight/brakelight assembly.
3. Install the new taillight/brakelight assembly and
secure with the lock nuts. Tighten securely; then con-
nect the electrical connector.
CHECKING/ADJUSTING HEADLIGHT
AIM
The headlights can be adjusted vertically. The geometric
center of the HIGH beam light zone is to be used for verti-
cal aiming.
1. Position the vehicle on a level floor so the headlights
are approximately 6.1 m (20 ft) from an aiming sur-
face (wall or similar aiming surface).
WC360B
 NOTE: There should be an average operating load
on the vehicle when adjusting the headlight aim.
2. Measure the distance from the floor to the mid-point
of each headlight.
3. Using the measurements obtained in step 2, make hor-
WC360A
izontal marks on the aiming surface.
4. Switch on the lights. Make sure the HIGH beam is on.
DO NOT USE LOW BEAM.
5. Observe each headlight beam aim. Proper aim is when
the most intense beam is 5 cm (2 in.) below the hori-
zontal mark on the aiming surface.
6. Adjust each headlight until correct aim is obtained by
turning the screw with a 4 mm wrench counterclock-
wise to raise or clockwise to lower the beam.
WC099A
0740-647
WC361A
13