Accelerator Pedal; Headlight Switch; Reverse Override Switch - Arctic Cat 2012 Prowler XT Operator's Manual

! WARNING
The seat belt indicator is only a
reminder and automatically
guishes after approximately eight sec-
onds. It does not indicate that seat belts
are properly secured. It is the operator's
responsibility to ensure all vehicle
occupants are properly seated with seat
belts secure and occupant
restraints are properly secured. Serious
injury or death could occur as a result
of falling outside a moving vehicle.
Park Indicator Light
When the parking brake is applied, the
indicator light will illuminate.

Headlight Switch

Use the headlight switch to select the high
or low headlight beam. When the switch is
in the HI position, the high beam will illu-
minate. When the switch is in the LO
position, the low beam will illuminate.

Reverse Override Switch

This vehicle is equipped with a reverse
speed limiter system. When additional
RPM is needed in reverse, depress and
hold the override switch located on the
center console.
NOTE: The vehicle must be in 4WD
to activate the reverse override.
! WARNING
Never activate the override switch
extin- while the throttle is open as a loss of
control could result.

Accelerator Pedal

Press down on the pedal to increase
engine RPM and vehicle speed; release
the pedal to decrease engine RPM and
side
vehicle speed.
NOTE: This vehicle is equipped
with an RPM limiter that retards
ignition timing
RPM is approached. When the RPM
limiter is activated, it could be mis-
interpreted as a high-speed misfire.
Seat Latches
1. To remove the seat, lift up on the
latch release (located at the front of
the seat); then raise the front of the
seat and slide it forward.
2. To lock the seat into position, slide
the rear of the seat into the seat retain-
ers and push down firmly on the front
of seat. The seat should automatically
PR745B
lock into position.
! WARNING
Make sure the seats are secure
before driving the vehicle. Serious
injury or death could result if the
seats are not properly secured.
Seat Belts
This vehicle is equipped with seat belts
for the operator and the passenger. To
fasten and release the seat belt properly,
PR745C use the following procedure.
1. Place the seat belt across your lap as
low as possible without twisting the
belt making sure the shoulder strap is
below the neck and across the chest.
! WARNING
Only appropriate-sized passengers
may ride in this vehicle. Passengers
must be able to place both feet flat on
the floor while keeping their back
against the back of the seat and hold-
ing on to the hand holds.
when maximum
27