Arctic Cat Wildcat ROV 2013 Service Manual page 166

4. If clearance is not as specified, repeat steps 1 and 2
using thicker (clearance too great) or thinner (clear-
ance too small) until correct specification is reached.
REAR DRIVE INPUT SHAFT/
HOUSING
Removing/Disassembling
1. Remove the cap screws securing the rear drive input
shaft/housing to the rear gear case; then remove the
input housing assembly.
2. Remove the clutch pack from the clutch basket; then
remove the snap ring securing the clutch basket (A) to
the input shaft (B) and remove the clutch basket.
3. Remove the input shaft from the input housing; then
remove the oil seal.
GZ183
GZ392
4. Remove the snap ring retaining the input bearing and
using an appropriate bearing driver, press the bearing
from the housing.
GZ176A
GZ177
GZ180
GZ182A
GZ184A
163