Accelerator Pedal; 2Wd/4Wd Selector; Front Differential Lock (Xt) - Arctic Cat 2007 Service Manual

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983

Accelerator Pedal

REMOVING
To remove the accelerator pedal, dislodge the throt-
tle cable holding grommet from the actuator arm;
then remove two torx-head screws and nuts securing
the accelerator pedal assembly to the splash panel
and remove the accelerator pedal.
INSTALLING
To install the accelerator pedal, align the mounting
holes with the holes in the splash panel and secure
with the two torx-head screws and nuts; then snap
the throttle cable holding grommet into the actuator
arm.

2WD/4WD Selector

The automatic drive selector allows the operator to
operate in either 2-wheel drive (rear wheels) or
4-wheel drive (all wheels). For normal riding on
flat, dry, hard surfaces, 2-wheel drive should be suf-
ficient. In situations of aggressive trail conditions,
4-wheel drive would be the desired choice.
www.mymowerparts.com
Back
PR342B
PR342C
Back to TOC
To either engage or disengage the front wheels,
move the switch to the 4WD position or to the 2WD
position.
! CAUTION
Do not attempt to engage or disengage the front dif-
ferential while the vehicle is moving.
Front Differential Lock
(XT)
The front differential lock allows the operator to
mechanically lock the differential to apply equal
power to both front wheels. To engage the front dif-
ferential lock, pull the DIFF LOCK toggle out; to
disengage the front differential lock, push the DIFF
LOCK toggle in.
ADJUSTING CABLE
1. With the toggle in the pushed-in position, slide
the rubber protector sleeve (A) off the cable near
the toggle; then loosen the jam nut (B) and turn
the cable adjuster (C) to achieve 3-4 mm
(0.12-0.16 in.) free-travel measured at the tog-
gle.
Back to Section TOC
PR083
9
CD560C
Next
9-3