Checking/Adjusting Front Wheel Alignment; Accelerator Pedal - Arctic Cat Wildcar Trail Service Manual

9. Install the wheel; then using a crisscross pattern,
tighten the wheel nuts in 20 ft-lb increments to a final
torque factor of 40 ft-lb (steel wheel) or 80 ft-lb (alu-
minium wheel).
10. Remove the vehicle from the support stand.
Checking/Adjusting Front
Wheel Alignment
 NOTE: All measurements and adjustments must be
made with the vehicle unloaded.
 NOTE: Make sure the white alignment marks of the
steering rack are aligned.
Mark the center-line of the front tires at the front and rear
of the tire; then using a tape measure, measure and record
the distance between the marks at the front and rear. The
front measurement should be 3-6 mm (1/8-1/4 in.) greater
than the rear measurement (toe-out).
WT287A
To adjust the wheel alignment, use the following procedure:
1. Center the steering rack; then using an open-end
wrench to hold the tie rod (B), loosen the right-side
and left-side jam nuts (A).
Always use a wrench to hold the tie rod ends when loos-
ening or tightening the jam nuts or damage to the boots
could occur.
2. Turn the left-side and right-side tie rods (B) in equal
increments to achieve the proper toe-out; then tighten
to 25 ft-lb.

Accelerator Pedal

WT080A
REMOVING
Dislodge the yellow nylon bushing of the throttle cable
from the actuator arm; then remove two torx-head screws
and nuts securing the accelerator pedal assembly to the
splash panel and remove the accelerator pedal.
CAUTION
WT292A
WT039A
29