Led Indicator - Sierra Wireless AirLink ES440 User Manual

ALEOS 4.4.0 Software Configuration User Guide
224

LED Indicator

You can configure the Activity LED on the AirLink device to flash red when traffic
is being transmitter or received over the serial port.
Figure 10-11: ACEmanager: Serial > LED Indicator
Table 10-7: Serial > LED Indicator
Field
Display Options are:
•
Disable (default)
•
Enable
If this field is set to Enable, the Activity LED on the AirLink device
flashes red when traffic is being transmitted/received on the serial port
selected in the Serial Port field.
Off
Flashing Green
Flashing Red
Flashing Yellow
You can also use an AT command to configure this field. See
*SERIALLEDDISPLAY
behavior, refer to the AirLink device Hardware User Guide.
Serial Port If you have an AirLink GX device with an I/O X-Card installed, use this
field to select the serial port you want the LED to indicate traffic on.
•
Primary—Serial port on the AirLink device itself (default)
For all other AirLink devices, leave this field set to the default value.
You can also use an AT command to configure this field. See
*SERIALLEDPORT
Description
Activity LED
No traffic
Traffic on WAN interface
Traffic on selected serial port
Traffic on both the WAN interface and
selected serial port
on page 323. For a complete list of LED
on page 324.
Traffic
4116359