Additional Behavior And Features; Configuring Events Reporting - Sierra Wireless AirLink ES440 User Manual

ALEOS 4.4.0 Software Configuration User Guide
198
3. The measurement is compared to the configured threshold or state change. If
there is no change, then another measurement is performed. If a state
change (or threshold crossing) occurs, then the flow moves to step 4.
4. The Action associated with the Event in this step occurs. A report may be
generated or some other activity is performed. Afterwards, the flow returns to
step 1.

Additional Behavior and Features

Events/Actions are not one shot activities. After an Action is performed, the Event
is still active and will trigger the next time the state change or threshold crossing
occurs.
A single Event may activate one or more Actions. For example, if RSSI is below
threshold, you can send an email (Action 1) and send an SNMP TRAP (Action 2).
A single Action may be activated by one or more Events. For example, if network
state changes to Network Ready, or the RSSI crosses a configured threshold,
either Event can perform the same action.
After defining an Event, always select the Apply button to save these definitions
and apply them to an Action.
Selecting the Delete button on the Events Reporting tab will delete all current
Event and Action data.

Configuring Events Reporting

When configuring Events Reporting, first configure the event you want reported.
Then configure the Action (that is, how you want to be notified when the event
occurs), and finally, link the Event to the Action.
Note: All Events Reporting configuration changes take effect after a short delay (about one
minute). No reboot of the AirLink device is necessary.
To configure Events and Actions:
1. In ACEmanager, go to Events Reporting.
2. Select Actions from the menu on the left of the screen.
4116359