Device Updates; Status - Sierra Wireless AirLink ES440 User Manual

Table C-1: Device Update AT Commands
Command
*TPLUPDATE
Command
*BAND?
*CELLINFO?
*CELLINFO2?
+CIMI?
*DEVICEID?
Rev 1 Nov.14

Device Updates

Description
This AT command updates the template (configuration file) remotely.
The template file must be accessible on an FTP server.
The command parameters are:
AT*TPLUPDATE=<Server_IP>,<USER_NAME>,<PASSWORD>,<FILE_NAME>
where:
•
SERVER_IP is the IP address of the FTP server.
•
USER_NAME is the user name used to access the FTP server.
•
PASSWORD is the password used to access the FTP server.
•
FILE_NAME is the name of the template file on the FTP server that you want to apply to
the AirLink device. The template file must be stored on the FTP User_Name home, not in
a sub-folder.
Example:
AT*TPLUPDATE=192.168.17.111,MyUserName,MyPassword,NewTemplate.xml
When the template is successfully applied, the message displayed is:
Template applied successfully
OK
Note: Configure the FTP server:
•
As passive mode (not active mode)
•
To listen to port 21

Status

Description
HSPA and LTE fallback to HSPA only.
Query the current radio module band.
Query cellular connection information.
Query in depth cell information.
HSPA and LTE only.
Query the IMSI.
When the device is configured to use the device ID, this command displays the 64-bit
device ID created from the ESN/IMEI or phone, preceded by the hex delimiter (0x). For
example:
at*deviceid?
0x010112DE140B5A32
295