Led Operation - Sierra Wireless AirLink GX Series Hardware User's Manual

AirLink GX Series Hardware User Guide
Table 2-3: LED Behavior
LED Color / Pattern
Power Off
Solid Green
Flashing Yellow / Green
Solid Yellow
Solid Red
Signal Solid Green
Solid Yellow
Solid Red
Flashing Red
32
· Power cable is connected to power (line or battery power)
· Power is turned on or that the battery is fully charged
· Ignition Sense (pin 3) is connected to the battery or power source (see
Connecting a DC Power Cable
For information on configuring the GX Series device, see
Series devices on page 47.

LED Operation

Power-up and Reboot
On power-up or reboot, all LEDs turn red, then yellow, then green. They then go
through a blinking sequence that ends with the Power LED green and all the other
LEDs off. Once the other LEDs resume their normal operating behavior, the
reboot is complete.
To reboot the device:
• In ACEmanager, click the Reboot button at the top right of the screen.
• Press and release the Reset button on the device (see
page 10). Do not hold the button down for more than a few seconds. (If you
hold it for 7–10 seconds, the device resets to factory default settings.)
LED Behavior
No power or input voltage
Device is connected to nominal power and is operating normally.
Device has a GPS fix
Device is entering low power mode or system low level boot.
Device is not operational (failure or in low power mode).
Good signal
(RSSI
Marginal signal (-100 dBm
Poor signal (-110 dBm
No signal (RSSI
on page 34 for details)
Description
≥
36 VDC or
≥
-85 dBm)
<
RSSI
≤ ≤
RSSI
<
-110 dBm)
Configuring AirLink GX
Front Panel
≤
9 VDC
<
-85 dBm)
-100 dBm)
on
4114008