Rev 1 Nov.14
Figure 8-19: ACEmanager: Services > Authentication > RADIUS
3. Configure the other fields as described in the following table.
Field
RADIUS Server
Port
Timeout (seconds)
Secret
4. Click Apply.
TACACS+ Authentication
Terminal Access Controller Access-Control System Plus (TACACS+) uses TCP
protocol and encrypts the entire packet, except the header.
To configure TACACS+:
1. Go to Services > Authentication.
2. In the TACACS+ Client field, select Enable.
Description
RADIUS server IP address or resolvable domain name
By default, RADIUS uses UDP port 1812
The time limit for the server to respond
•
1–60 seconds
Default is 30 seconds.
Note: If the server does not respond during the timeout (no
route to host, server down, network too slow etc.), the
authentication fails and the next enabled authentication
mechanism checks the credentials.
Shared secret for configured server
Services Configuration
193