Table 10-4: Serial Port Configuration > UDP
Field
UDP
UDP Auto Answer
UDP Idle Timeout
(seconds)
Rev 1 Nov.14
UDP
Figure 10-4: ACEmanager: Serial > Port Configuration > UDP
Description
Whether the AirLink device auto answers and incoming UDP connection request
Options are:
•
Disable (default)
•
Enable
You can also use an AT command to configure this field. See
UDP Idle Time-out in seconds
Specifies a time interval upon which if there is no in or outbound traffic through a UDP
connection, the connection is terminated.
•
0— No idle time-out
•
1–255 Time-out in seconds (Default is 50.)
You can also use an AT command to configure this field. See
Serial Configuration
S82
on page 323.
S83
on page 323.
217