Configuring Ip To Serial With Auto Answer And Serial To Ip - Sierra Wireless AirLink ES440 User Manual

ALEOS 4.4.0 Software Configuration User Guide
Table 10-5: Serial Port Configuration > PPP
Field
a
PPP
Device PPP IP
Host PPP IP
a. Note: This section is only visible when PPP is selected in the Startup Mode Default field.
Receive packets; send payload
data out over serial
Receive payload data over serial;
create and send out packets
Both: receive packets; send payload
data out over serial AND receive
payload data, create and send out
packets
220
Description
Sets the device IP address (in private mode)
Sets the host IP address (in private mode)
Configuring IP to Serial with Auto Answer
and Serial to IP
You can configure the AirLink device to:
• Auto Answer incoming TCP/IP or UDP/IP connections and send the packet
payload out the AirLink device's serial port to a connected device
• Create and send TCP/IP or UDP/IP packets containing payload data that the
AirLink device receives over its serial port from a connected device
• Both receive and send TCP/IP or UDP/IP packets (that is, both of the above
functionalities)
Internet
TCP /IP packet
UDP/IP packet
TCP /IP packet
UDP/IP packet
TCP /IP packet
UDP/IP packet
Figure 10-7: TCP and UDP Auto Answer
To configure the AirLink device for TCP/UDP auto answer, sending IP packets or
both:
1. In ACEmanager, go to Serial > Port Configuration.
Serial
AirLink device
Packet contents
streamed over serial
Packet contents
streamed over serial
Packet contents
streamed over serial
Connected device
4116359