Serial - Sierra Wireless AirLink ES440 User Manual

ALEOS 4.4.0 Software Configuration User Guide
Table C-6: Services AT Commands
Command
*SNTP
*SNTPADDR
Table C-7: Serial AT Commands
Command
AIP
\APPP
*CTSE
DAE
320
Description
Query or set daily SNTP updates of the system time.
AT*SNTP? to query
AT*SNTP=n to set
•
n=0—Off
•
n=1—On
SNTP Server IP address, or fully-qualified domain name, to use if *SNTP=1.
AT*SNTPADDR? to query
AT*SNTPADDR=[d.d.d.d] or [NAME]
•
d.d.d.d=IP Address
•
NAME=FQDN

Serial

Description
Query or set the option to allow IP addresses to communicate on UDP over serial.
AT*AIP? to query
AT*AIP=n to set
•
n=0 — Allow only the IP address specified in S53 to connect when UDP auto
answer is enabled (S82=2)
•
n=1 — Allow any incoming IP address to connect when UDP auto answer is
enabled (S82=2)
Always subject to any security filters that may be defined. (See
page 312.)
Initiates a PPP connection on serial terminal.
You can also initiate a PPP connection using the ADT command and one of the
supported phone numbers.
Query or set asserting Clear To Send (CTS) when there is a network coverage.
AT*CTSE? to query
AT*CTSE=n to set
•
n=0 — Disabled (default)
•
n=1 — Enable assertion of CTS when there is network coverage
Query or set AT Escape Sequence detection.
ATDAE? to query
ATDAE=n to set
•
n=0 — Enable
•
n=1 — Disable (The escape sequence (+++) is ignored.)
Security on
4116359