Led Behavior; Step 7-Use The Fx30S - Sierra Wireless Octave FX30S User Manual

LED Behavior

Table 2-5: LED Behavior
LED
Power
(Default Behavior)
Note: Based on three GPIOs. To define
the behavior of this LED, see
on page 77.
User
Note: Based on two GPIOs. To define the
behavior of this LED, see
page 77.
Note: You can write Legato applications to
define User LED behavior.
Step 7—Use the FX30S
You can use the FX30S as:
•
•
Rev. 5 September 2020
Color / Pattern
Off
Solid Red
Solid Amber
Power LED
Possible colors:
Red
•
Green
•
Amber
•
User LED on
A USB modem—You can use the FX30S as a USB bitpipe modem based on the
Qualcomm proprietary RMNET interface. This can be done through AT commands
using AT!SCACT to open and close the data session. For more information and a
detailed example, see Using the FX30S as a USB Modem
An embedded cellular platform for IoT applications—Use AT commands, Linux shell
commands, or Legato to configure/program. See
User LED Power LED
No power or input voltage
Gateway is powered on, not attached to cellular
network.
Attached to cellular network.
User-defined behavior
31
Installation and Startup
Description
≥ 32 VDC or
on page 64.
page 33.
≤ 4.75 VDC
41110485