ALEOS 4.4.0 Software Configuration User Guide
Table 10-1: Serial Port Configuration > Port Configuration
Field
Port Configuration
Startup Mode Default
208
Port Configuration
Figure 10-1: ACEmanager: Serial > Port Configuration > Port Configuration
Description
Default power-up mode for the serial port. When the AirLink device is power-cycled, the
serial port enters the communication mode specified.
Note: It can take up to 5 minutes to establish a connection.
•
Normal (AT command) default
•
PPP
•
UDP
•
TCP
•
Reverse Telnet/SSH—Allows you to telnet or SSH into a router or other device
connected to the AirLink device via a serial port. For information on configuring
reverse telnet, see
Reverse Telnet/SSH
•
UDP Multiple Unicast—This option is not supported on the ES440.
You can also use an AT command to configure this field. See
on page 210.
MD
on page 321.
4116359